Difference between revisions of "Category:1-Wire"
From PhotoVoltaic Logger new generation
m |
m |
||
| (2 intermediate revisions by the same user not shown) | |||
| Line 8: | Line 8: | ||
* comment out <tt>server: FAKE = DS18S20,DS2405</tt> | * comment out <tt>server: FAKE = DS18S20,DS2405</tt> | ||
* uncomment/change for USB or serial devices | * uncomment/change for USB or serial devices | ||
| − | ** | + | ** <tt>server: usb = all</tt> |
| − | ** server: device = /dev/ttyS0 | + | ** <tt>#server: device = /dev/ttyS0</tt> |
| − | |||
| − | |||
| − | |||
| + | I have an USB <-> 1 wire Adapter with FT232RL & DS2480B and have to set | ||
| + | * <tt>server: device = /dev/ttyUSB1</tt> | ||
| + | ---- | ||
<references/> | <references/> | ||
Latest revision as of 13:08, 30 August 2014
1-Wire is a device communications bus system designed by Dallas Semiconductor Corp. that provides low-speed data, signaling, and power over a single signal.[1] 1-Wire is similar in concept to I²C, but with lower data rates and longer range. It is typically used to communicate with small inexpensive devices such as digital thermometers and weather instruments. A network of 1-Wire devices with an associated master device is called a MicroLan. Wikipedia:1-Wire
On Debian you have to install the following packages:
# sudo apt-get install owfs ow-shell
Afterwards change /etc/owfs.conf for your environment:
- comment out server: FAKE = DS18S20,DS2405
- uncomment/change for USB or serial devices
- server: usb = all
- #server: device = /dev/ttyS0
I have an USB <-> 1 wire Adapter with FT232RL & DS2480B and have to set
- server: device = /dev/ttyUSB1
Pages in category "1-Wire"
The following 3 pages are in this category, out of 3 total.
