Difference between revisions of "Category:1-Wire"
From PhotoVoltaic Logger new generation
m |
m |
||
| Line 4: | Line 4: | ||
On Debian you have to install the following packages: | On Debian you have to install the following packages: | ||
# sudo apt-get install owfs ow-shell | # sudo apt-get install owfs ow-shell | ||
| + | |||
| + | Afterwards change /etc/owfs.conf for your environment: | ||
| + | * comment out <tt>server: FAKE = DS18S20,DS2405</tt> | ||
| + | * uncomment/change for USB or serial devices | ||
| + | ** #server: usb = all | ||
| + | ** server: device = /dev/ttyS0 | ||
| + | |||
| + | I have an USB <-> 1 wire Adapter mit FT232RL & DS2480B and have to set | ||
| + | * server: device = /dev/ttyUSB1 | ||
<references/> | <references/> | ||
Revision as of 13:06, 30 August 2014
1-Wire is a device communications bus system designed by Dallas Semiconductor Corp. that provides low-speed data, signaling, and power over a single signal.[1] 1-Wire is similar in concept to I²C, but with lower data rates and longer range. It is typically used to communicate with small inexpensive devices such as digital thermometers and weather instruments. A network of 1-Wire devices with an associated master device is called a MicroLan. Wikipedia:1-Wire
On Debian you have to install the following packages:
# sudo apt-get install owfs ow-shell
Afterwards change /etc/owfs.conf for your environment:
- comment out server: FAKE = DS18S20,DS2405
- uncomment/change for USB or serial devices
- #server: usb = all
- server: device = /dev/ttyS0
I have an USB <-> 1 wire Adapter mit FT232RL & DS2480B and have to set
- server: device = /dev/ttyUSB1
Pages in category "1-Wire"
The following 3 pages are in this category, out of 3 total.
